Kioti KL701 Manual page 11

Travel speed should be such that complete control
and machine stability is maintained at all times. Where
possible, avoid operation near ditches, embankments and
holes. Reduce speed when turning, crossing slopes, and
on rough, slick or muddy surfaces.
never use your hand to check for suspected leaks
under pressure. Use a piece of cardbord or wood for this
purpose. Escaping hydraulic oil or diesel fuel leaking
under pressure can have sufficient force to penetrate the
skin and cause infection or serious injury, seek medical
attention immediately.
To prevent personal injury, relieve all pressure before
disconnecting fluid lines.
Before applying hydraulic pressure, make sure all
hydraulic connections are tight and components are in
good condition.
contact with overhead power lines can cause severe
electrical burn or death from electrocution.
Make sure there is enough clearance between raised
equipment and overhead power lines.
KL701-AU-01.indd 3
Add recommended rear tire liquid weight or rear wheel
weights for increased stability.
A loader attachment should be transported in a low
position at slow ground speeds. Make turns slowly and
use the tractor brakes cautiously. A loaded attachment in
the raised position alters the center of gravity location of
the machine and increases the possibility of mishaps.
Do not stand, walk or work under a raised loader or
attachment unless it is securely blocked or held in
position. Accidental movement of a control lever or leak
in the hydraulic system could cause the loader to drop, or
attachment to dump, causing severe injury.
Make sure all parked loaders on stands are on a hard
level surface with all safety devices engaged to prevent
loader from falling and being damaged or injuring
someone.
When using a loader, be alert of bucket position at all
times. Loader in raised position with bucket rolled back
can dump material on tractor causing damage or injury to
tractor and / or operator.
Always park loader with bucket attached to loader.
SAfETy PREcAUTiOnS 1-
2013-03-29 오전 11:25:04
1