Backrest Angle Adjustment - progeo YOGA User Manual

heights of 46/47/48/49 cm) (see table 2).
To adjust the front height:
Remove screws "C" (using a 4 mm Allen key)
Adjust the wheel in line with the pre-drilled holes on the forks
(short forks have 2 holes, medium forks have 4 holes, long
forks have 5 holes).
Replace the screws and tighten them firmly.
Adjustment of the front height becomes necessary
after the front wheels have been replaced with wheels
of different dimensions or simply because the user
wishes to modify the height of the front of the
wheelchair.
Every time the height is adjusted it is also necessary
to check and adjust the angle.
ALL possible adjustments can be performed only by
RehaTEAM or by any authorized and specialized
personnel .
6.6

Backrest angle adjustment

(figures 50, 51, 52, 53, 54)
To get a more correct upper body posture, it is possible to angle
adjust the backrest in four positions: three with close angle (less
than 90° to the seat) and one open angle (more than 90° to the
seat) (see drawing next figure 52).
Fig.49
The backrest adjustment on the wheelchair Progeo YOGA is
possible through the holes "F" located in the lower side of the
backrest tube that is connected to the adjustment axle by means
of the lever "L".
Each hole gives a different angle. In figure 54 all possible
configuration are shown.
THE ADJUSTMENT OF THE BACKREST IS A VERY
DELICATE OPERATION, in fact, the backrest tubes
are directly connected to the folding system of the
wheelchair.
ALL possible adjustments can be performed only by
RehaTEAM or by any authorized and specialized
personnel .
If the hereafter reported instruction for the backrest
angle adjustment is neglected, serious damaged to
the folding system may be caused.
Rehateam s.r.l. is not responsible for damages of the
folding system due to bad or erroneous adjustment or
straining during adjustment of the system.
YOGA 31