progeo YOGA User Manual page 35

normally. Rehateam s.r.l. can not be responsible for
injury or damage due to using the wheelchair
without the stretched calf strap in presence of
double footplate.
The double footplate can be flipped up easily pulling their plate up
with one hand (fig. 57). The footplate angle can be adjusted so as
to give a more comfortable support to the user's feet.
To perform the adjustment, loosen the bolt "A" (fig. 57a) (5 mm
Allen key) and turn the plate clock or anti-clockwise ,as shown in
the picture, to the desired inclination. Tighten the bolt "A" and
check that the joining system works well.
Fig. 57
To comply with the rule UNI EN 12183 paragraph
SEAT WIDTH
6.1, when double footrests are fitted it is necessary
to maintain the correct distance between the two
footrests when lowered:
1)The footrest distance (DIST) must not exceed
for wheelchairs used by adults
mm
Here below the correct footrest sizes based on seat
width are detailed
Footplate type
Model YOGA
Seat width
DST
Double footplate assembly drawing
Fig. 57a
.
Footplate type
36 150 x 160
39
170 x 160
42
170 x 160
200 x 160
45
One piece flip-up plastic footplate
This model can be raised by pulling up the footplate with one hand
(figure 58).When the footrest is lowered, make sure that the hooking
tooth is correctly inserted into the slot. To adjust the angle of the
one-piece footrest, just loosen the two bolts "A" (5 mm Allen key)
(fig 59) and turn the footrest, as indicated by the arrow, until the
desired position is reached. Finally tighten the two bolts "A".
A
35
Fig. 60
One-piece automatic closing plastic footrest
This footrest folds and unfolds automatically as the wheelchair is
closed and opened.(See chapter 5.2 and 5.3 "Closing and opening
system") (see figure 61). The angle of the one-piece automatic
Fig. 57 Fig. 59
Fig. 58
YOGA 35