progeo YOGA User Manual page 36

closing footrest can be adjusted exactly like the one piece flip-up
footplate (see section "One-piece flip-up plastic footplate").
Position of the one-piece footrests
In the order form, the one-piece footrests can be request to be
mounted in three different positions: 2/3 internal (fig.62/a – 62/d),
completely internal (fig.62/b – 62/e) or completely external (fig.62/c
– 62/f). These configurations exclusively depend on how the parts
are assemble.
One piece flip-up
Fig. 62a Fig. 62b
One piece with automatic closure
Fig. 62d Fig. 62e
Fig.61
Fig. 62c
Fig. 62f
Rotative system support
This kind of support (figure 63) allows a greater adjustment of the
footplate. It can be applied only to the plastic footplate (flip-up or
automatic closure or double for junior version).
To adjust the inclination and the position of the footplate,
loosen the bolts "A", "A1" and "B" (4 and 5mm Allen key)
(figure 80) helping yourself with a 10mm spanner for the nut
matched to the bolt "A1".
Perform the height and position adjustment by rotating the
lever "C".
Once reached the desired position, ad just the inclination and
fix all bolts.
Fig.63
One piece flip-up carbon fibre footplate
This model can be raised by pulling up the carbon fibre plate with
one hand (fig.64). When lowering the footplate, ensure that the
engaging tooth locks in its bed. To adjust the angle of one-piece
footrest it is sufficient to loosen the two bolts "L" (5 mm Allen key)
and turn the footrest, as indicated by the arrow, (fig. 82) until the
desired position is reached.
Finally tighten the two bolts.
YOGA 36