Introduction - ETC Irideon FPZ User Manual

Introduction

The Irideon FPZ takes the beauty and punch of the Source
Four Mini beam and puts it into a fixture designed to work
in any architectural environment. With built in zoom optics,
three-plane shutters and a rotating barrel, the FPZ can
create a sharp or soft focused light in any shape you need.
When used with either glass or metal gobos, logos and
designs look great. With the addition of local level control
as well as individual DMX addressing, the Irideon FPZ can
do it all, and look great while doing it.
WARNING:
WARNING:
WARNING:
AVERTIR:
INSTRUCTIONS PERTAINING TO A RISK OF FIRE, ELECTRIC SHOCK, OR INJURY TO
PERSONS
IMPORTANT SAFETY INSTRUCTIONS
WARNING - To reduce the risk of FIRE, ELECTRIC SHOCK, OR INJURY TO PERSONS:
1) Keep lamp away from materials that may burn.
2) External temperature after 5 minutes of full-brightness operation
3) External temperature when steady state is achieved 54°C (129°F).
SAVE THESE INSTRUCTIONS
User Manual
Please note the following safety warnings before use:
Do not mount the fixture on or near combustible surfaces.
Do not operate the fixture without a lens installed, or with
a scratch or cracked lens. Damaged lenses must be
replaced.
Use the Irideon FPZ fixture in dry locations only, where
humidity does not exceed 90 percent (non-condensing).
These fixtures are not intended for outdoor use.
Use with ceiling-mounted track only.
To reduce the risk of fire and electric shock, use the track
mount version only with the EUTRAC track system.
Pour éviter le risque d'incendie ou de choc électrique
utiliser seulement avec une alimentation par rail EUTRAC.
34°C (93°F)
1