Installation; Installation Requirements; Leveling - Alto-Shaam CS-200 Installation Operation & Maintenance

S I T E I N S T A L L A T I O N
W A R N I N G
Improper installation, alteration,
adjustment, service, cleaning, or
maintenance could result in property
damage, severe injury, or death .
READ and UNDERSTAND the
installation, operating and
maintenance instructions thoroughly
before installing, servicing, or
operating this equipment .
C A U T I O N
To prevent SEVERE PERSONAL
INJURY or PROPERTY DAMAGE:
ALWAYS use hand protection when
operating this appliance to avoid
burns . Metal parts of this equipment
become extremely hot when in
operation .
S I T E I NS T A L L A T I O N
1. The appliance, complete with unattached items
and accessories, may be delivered in one or more
packages. Check to ensure all accessories ordered
have been received.
2. The hot carving station is designed to be mounted
directly on top of a Halo Heat Cook & Hold oven
or holding cabinet. The shelf can also be used as a
free-standing unit.
HEATED CABINET MOUNTED SHELVES:
Remove the 1" (25mm) legs prior to placing the
carving shelf on top of the Halo Heat cook/
hold oven or holding cabinet. Appliance must be
installed on a stable and level surface.
FREE-STANDING SHELVES:
Ensure that the 1" (25mm) legs are in place prior to
placing the carving shelf on work surface. Failure
to operate without the 1" (25mm) legs prior to
heating the shelf could result in damage to the
surface on which the shelf is placed, may pose a
potential fire hazard, and nullifies the validity of
the UL listing mark. Appliance must be installed on
a stable and level surface.
3. DO NOT install this appliance in any area where it
may be affected by any adverse conditions such as
steam, grease, dripping water, high temperatures,
or any other severely adverse conditions.
I N S T A L L A T I O N
MN-29250 (Rev. 3) 11/15 • CARVING STATIONS • 4
W A R N I N G
Appliance and accessories may be
heavy . To prevent serious injury,
ALWAYS use a sufficient number
of trained and experienced workers
when moving or leveling appliance
and handling accessories .
C A U T I O N
The performance of this unit has been
optimized using the factory provided
bulbs . These bulbs should be replaced
with an exact replacement or with a
factory recommended replacement .
These bulbs have been treated to
resist breakage and must be replaced
with similarly treated bulbs in order
to maintain compliance with NSF
standards . DO NOT over-tighten bulbs
in their receptacles as this may cause
damage to the bulb fi lament .
4. DO NOT install near a cold air source such as a
freezer, air conditioning vents, or in any area where
outside air fluctuation can affect performance.
5. This appliance must be kept free and clear of any
obstructions blocking access for maintenance or
service.
6. Lift Breath Guard up and slide into place in
brackets found in the front of the appliance.
A number of adjustments are associated with initial
installation and start-up. Installation and start-up
adjustments are the responsibility of the dealer or
user. These adjustments include but are not limited to
leveling, electrical hook-up and installation of bulbs.

LEVELING

Level the appliance
from side-to-side and
front-to-back with
the use of a spirit level.
NOTICE: F ailure to properly level this appliance can
cause improper function.