Installation - Alto-Shaam 100-HW Installation, Operation And Maintenance Manual

E L E C T R I C A L C O N N E C T I O N
1. An identification tag is permanently mounted
on the appliance.
2. This appliance is equipped with a three-prong
grounding plug. For your protection against
shock hazard this appliance should be plugged
directly into a properly grounded three-prong
receptacle. Do not cut or remove the grounding
prong from this plug. Plug the unit into a
properly grounded receptacle ONLY, positioning
the unit so that the plug is easily accessible in
case of an emergency. Arcing will occur when
connecting or disconnecting the unit unless all
controls are in the "OFF" position.
3. Proper receptacle or outlet configuration or
permanent wiring for this unit must be
installed by a licensed electrician in
accordance with applicable local
electrical codes.
I N S T A L L A T I O N
4. For 230V units:
To prevent an electrical shock hazard between the
appliance and other appliances or metal parts in
close vicinity, an equalization-bonding stud is
provided. An equalization bonding lead must be
connected to this stud and the other appliances /
metal parts to provide sufficient protection
against potential difference. The terminal is
marked with the following symbol.
NOTE:
electrical circuit that is protected by an external
GFCI outlet.
#808 H o t f o o d Dro p -In We ll • 4.
The appliance must be connected to an
ELECTRICAL CONNECTIONS MUST
BE MADE BY A QUALIFIED SERVICE
TECHNICIAN IN ACCORDANCE WITH
APPLICABLE ELECTRICAL CODES.
To avoid electrical shock, this
appliance MUST be adequately
grounded in accordance with local
electrical codes or, in the absence of
local codes, with the current edition
of the National Electrical Code
ANSI/NFPA No. 70.
electrical connections are to be made
in accordance with CSA C22.1,
Canadian Electrical Code Part 1 or
local codes.
In Canada, all