Table of Contents
Advertisement
Managing the Switch
switch#
Provides the available space information for the standby supervisor module.
To exit the module-specific prompt, use the exit command.
Note
Saving the Module Configuration
To save the new configuration along with the non-default VDC configuration to nonvolatile storage, use the
copy running-config startup-config vdc-all command from EXEC mode. Once you enter these commands,
the running and the startup copies of the configuration are identical.
The following table lists various scenarios when module configurations are preserved or lost.
Scenario
A particular switching module is removed and you
used the copy running-config startup-config vdc-all
command again.
A particular switching module is removed and the
same switching module is replaced before you enter
the copy running-config startup-config vdc-all
command again.
A particular switching module is removed and
replaced with the same type switching module, and
you entered the reload module slot_number
command.
A particular switching module is reloaded when you
enter the reload module slot_number command.
Displaying Power Usage Information
To display the power usage information for the entire switch, use the show environment power command.
This command shows the power usage for many of the modules installed in the switch. For the older modules
that do not have the capability to output this information, the output is shown as N/A.
Note
Power usage is reserved for both supervisor modules regardless of whether one or both supervisor modules
are present.
Enter the show environment power command.
OL-31330-01
Saving the Module Configuration
Consequence
The configured module information is lost.
The configured module information is preserved.
The configured module information is preserved.
The configured module information is preserved.
Cisco Nexus 7706 Hardware Installation Guide
63
Advertisement
Table of Contents
