Table of Contents
Advertisement
Installing the Switch Chassis
• Front door kit — Optional (N77-C7706-FDK)
• Front door (1) (69-2532-01)
• M3 x 8 mm pan-head screws (2) (48-0393-01)
• Air filter kit — Optional (N77-C7706-AFLT)
• Air filter (1) for the front door
• Door-side brush filters (2)
• Cable-management frame brush filters (2)
• M4 x 12 mm flat-head Phillips screws (12)
Step 2
Check the contents of each box for damage.
Step 3
If you notice any discrepancies or damage, send the following information to your customer service representative by
email:
• Invoice number of the shipper (see the packing slip)
• Model and serial number of the missing or damaged unit
• Description of the problem and how it affects the installation
Attaching Bottom-Support Rails to a Two-Post Rack
The bottom-support rails support the weight of the switch chassis in the rack or cabinet. To maximize the
stability of the rack, you must attach these rails at the lowest possible rack unit (RU).
Warning
To prevent bodily injury when mounting or servicing this unit in a rack, you must take special precautions to
ensure that the system remains stable. The following guidelines are provided to ensure your safety:
• This unit should be mounted at the bottom of the rack if it is the only unit in the rack.
• When mounting this unit in a partially filled rack, load the rack from the bottom to the top with the
• If the rack is provided with stabilizing devices, install the stabilizers before mounting or servicing the
Statement 1006
Before you begin
Before you can install the bottom support rails for the chassis, you must do the following:
• Verify that a two-post rack is installed and secured to the concrete subfloor (see
OL-31330-01
heaviest component at the bottom of the rack.
unit in the rack.
Cabinet).
Attaching Bottom-Support Rails to a Two-Post Rack
Cisco Nexus 7706 Hardware Installation Guide
Installing a Rack or
17
Advertisement
Table of Contents
