Table of Contents
Advertisement
Overview
Figure 2: Standard Hardware Features on the Rear of the Cisco Nexus 7706 Chassis
1
Three fan trays—only two fan trays,
N77-C7706-FAN, are shown in this figure, one
is removed to show the two fabric modules in
back. There are 2 types of fan trays: 38 mm Gen
1 fan trays (N77-C7706-FAN) and 76 mm Gen
2 fan trays (N77-C7706-FAN-2). Use the Gen
2 fan trays for Network Equipment Building
System (NEBS) compliance when the Cisco
Nexus 7700 M3-Series 12-port 100-Gigabit
Ethernet I/O module (N77-M312CQ-26L) is
installed on the switch.
2
Fabric modules (up to six with two behind each
fan tray) (N77-C7706-FAB-2 and
N77-C7706-FAB-3)
3
LEDs for the fan tray and fabric modules behind
the fan tray
The following figure shows the optional features seen on the front of the Cisco Nexus 7706 chassis.
OL-31330-01
Overview of the Cisco Nexus 7706 Switch Installation Features
4
Handles used only for adjusting the position of
the chassis on the mechanical lift or on the
bottom support rails (do not lift the chassis with
these handles)
5
Vertical mounting brackets used for securing
the chassis to the rack and for holding the cable
management frames
Cisco Nexus 7706 Hardware Installation Guide
3
Advertisement
Table of Contents
