Ignition Source (Id=1004); Ignition Detection(Id=1008); Ignition Detection Timeout(Id=1009); Gnss Fix Timeout For Time Synchronization Via Ntp (Id=1007) - Teltonika FM3622 User Manual

8.2.6
Parameter
8.2.7
Parameter
8.2.8
device will not detect "ignition off" state.
Minimum
value
8.2.9
– use default (GNSS) time synchronization method. However if the GPS time FIX is not received:
a. FM is going to get time using NTP server. Device will activate GPRS context and create UDP
connection to destination port 123 using SNTP protocol.
Minimum
value
Downloaded from www.Manualslib.com

Ignition Source (ID=1004)

Ignition Source sets ignition triggered functionalities.
Ignition Source
High Voltage Level*
Low Voltage Level*
* - used when External voltage selected as ignition source.

Ignition Detection(ID=1008)

This parameter defines ignition detection.
Manual – ignition detection is by parameters set by user(13-30V)
Automatic – ignition is detected by device:
Power voltage(12V) – ignition on 13.2 - 30
Power voltage (24V) – ignition on 27 – 30
Ignition Source

Ignition Detection Timeout(ID=1009)

This parameter defines time, in which Power Voltage can be lower than set value.
For example, Power Voltage drops from 14V to 12V for 5 seconds(timeout is set to 10)
Maximum Recommended
value
0 65535

GNSS FIX Timeout for Time Synchronization via NTP (ID=1007)

If "GNSS FIX Timeout" is set too 60s (default value) and during this time GPS FIX is received
Maximum Recommended
value
0 65535
manuals search engine
ID Value
1004
1005
1006
ID Value
1008
Goes with (depends on)
value parameters
10
Goes with (depends on)
value parameters
60
0 (By Power Voltage – default)
1 (By Ignition Din1)
2 (By Movement sensor)
Min: 0, Max: 30000 (mV)
Min: 0, Max: 30000 (mV)
0 - Manual
1 - Automatic
Value
type
U8
Value
type
U8
65