D a m p e r B e a r i n g R e p l a c e m e n t
Loosen the cap screws and remove the bearing assembly from the
1
shock.
The dust covers may fall off. This is normal.
If you are completing the 50 or 200 hour service, set the bearing assembly aside until service is complete. The air can cannot be removed with the
bearing assembly installed.
Install the new bearing assembly and screws onto the shock. Tighten
2
the cap screws to 6.2 N·m (55 in-lb).
3 mm
N OTIC E
3 mm
6.2 N•m (55 in-lb)
Damper Bearing Replacement
18