Sending Transactions Manually; Replacement Of The Paper Roll - Ingenico ICT220 User Manual

NB! IF THIS REPORT IS NOT PRINTED OUT, APPARENTLY THE TRANSACTIONS HAVE NOT REACHED
THE BANK!
Automatic sending is not performed where

No transactions were made after the last report has been sent

Sending was not successful, since the terminal was not plugged into the power network or the communication line used
by the terminal was not available.
Where automatic sending fails:

SEND TRANSACTIONS MANUALLY
NB! Where automatic sending fails, contact customer service of Nets Estonia.
7.2

SENDING TRANSACTIONS MANUALLY

The terminal is in the standby mode.
Press F1 key
From the menu select "Saatmine" and then press the green key (ENTER) to confirm.
If you wish to send transactions, press JAH or press the green key (ENTER).
The terminal shall dial the control center's number.
The terminal sends transactions
At the end of the communication session the terminal shall issue the report that demonstrates the number of transactions and
the total sum.
8.

REPLACEMENT OF THE PAPER ROLL

If a red line appears on receipts, the paper roll shall be replaced. Use only special thermal paper for the terminal.
1.-2. Open the paper roll cover
3. Place a new roll in place
4. Close the cover, tear off any excess paper
ACTION
16
SCREEN
TERE TULEMAST
Tehingud
1-Saatmine
2-Annulleerimine
3-Kaarditehing
4-Käsitsitehing
Tehingud
Saadan tehingud?
Oled kindel?
Ei Jah
ÜHENDUS
PALUN OODAKE
SAATMINE