Supermicro SuperServer 6049P-E1CR45H User Manual page 46

SuperStorageServer 6049P-E1CR45H/L/L+ User's Manual
Installing a 3.5" Storage Drive
With the drive carrier removed from the storage compartment:
1. Under the main carrier handle, find and the lift the breakout lever and pull out the side
of the carrier.
Carrier
Breakout
Lever
2. Remove the dummy drive from the carrier.
3. Insert the hard drive into the drive carrier. Orient the drive by matching the two
alignment pins on the side and by noting the notch in the carrier for the drive
connectors. Close the side of the carrier until it snaps in place.
4. Slide the carrier assembly into its spot in the chassis until it clicks into locked position.
Alignment Pins
Notch for Connectors
Figure 3-8. Opening the Drive Carrier
46
Pull Out Side
of Carrier