Table of Contents
Advertisement
7. Use the six Velcro straps to secure the cables to the CMA. Use a strap on either side of
each joint and one on each U-bracket, inserting it through the slot on the bracket.
8. Slide the chassis forward and backward in the rack to confirm that the cable
management arm is operating smoothly. If necessary, loosen the straps for smoother
movement.
If at some time you must remove the cable management arm, follow this procedure.
Removing the Cable Management Arm
1. Remove cables from the CMA, releasing the Velcro straps and the red plastic caps.
2. For CMA connector #4, pull the metal release tab toward the center of the rack and slide
the connector toward the rear to release it.
3. For CMA connectors #3, #2, and #1, depress the front edge of the yellow plastic rocker
lock, and slide the connector toward the rear to release it.
Chapter 2: Server Installation
31
Advertisement
Table of Contents
