Winding The Bobbin Thread - Bernina 435 Instruction Manual

> Thread the first thread into the left needle manually.
> Thread the second thread into the center needle manually.
> Thread the third thread into the right needle manually.

Winding the bobbin thread

The bobbin thread can be wound while sewing when the retractable spool pin is used for winding.
Prerequisite:
• The foam pad, the thread spool and the appropriate spool disc are positioned.
> Attach the empty bobbin on the winding unit so that the silvery sensor surface is down.
> Guide the thread to the left into the rear thread guide (1).
> Guide the thread around the thread pretension clockwise (2).
> Wind the thread clockwise 2 to 3 times around the empty bobbin (3).
> Pull the thread over the thread cutter at the engaging lever (4) and cut.
1
2
> Push the engaging lever (5) towards the bobbin.
– The machine is winding.
> To stop the winding process, the engaging lever must the pressed to the right.
> Push the engaging lever towards the bobbin again to continue the winding process.
– As soon as the bobbin is full, the machine stops the winding process automatically.
> Remove the bobbin and cut the thread using the thread cutter at the engaging lever.
3
4
5
Sewing preparation
45