Mitsubishi PKH-1.6GKLH Technical & Service Manual page 64

2-3. How to connect program timer
(1) Install the program timer next to the remote controller the same way as the remote controller is installed.
(2) Connect the program timer and the remote controller with a 6-wire cable as shown in the figure below
2-wire cable To indoor unit
FILTER
CHECK MODE
TEST RUN
4
5-wire cable
Connector CN1
2-4 Names and functions
<PAC-SC32PTA>
WEEKLY TIMER SETTING DISPLAY
Used for selection of if or not the day operation
pattern set by PATTERN SETTING is to be
applied in weekly day unit, setting.
SET/MONITOR DISPLAY
During SET is display, clock adjustment,
change of weekly day, daily and weekly timer
setting can be performed.
During MONITOR is display, all switches
except SET/MONITOR SW are invalidated.
This is normal status.
WEEK DAY SETTING SW
Used for week day setting.
MODE SELECTOR SW
Using this switch select "MONITOR" or "SET"
Mode.
"MONITOR" :Indicates the current timer set-
ting. All switch expect MODE
SELECTOR SW are invalidated
then. This is the normal status.
"SET": Set to "SET" mode for clock adjustment,
charge of week day, daily and weekly
timer setting.
3. TIMER ADAPTER
This adapter is needed for system control and for operation via external contacts. Adapter connection is described on page .
Part No.
ORN 1
2
BRN
3
RED
OC229A
NOTE: While the program timer is connected to the remote controller, the
2hour ON/OFF timer on the remote controller will not operate.
SET BACK
S M T W T F S
SET
0 3 6 12 15
MONITOR
12 15 18 21 24
WEEKLY
DAILY
SET/MONITOR TODAY SETTING SET BACK
ON SETTING
ON SET BACK
OFF
CLOCK OFF DAILY TIMER
PROERAN TIMER
PAC-SC32PTA
Connector CN1
CURRENT TIME DISPLAY
During MONITOR status,current
time is display.
During Daily timer setting, a
time desire for timer setting is
displayed.
SET
MONITOR
SET/MONITOR TODAY
PROERAN TIMER
PAC-SC32PTA
CLOCK ADJUSTMENT SW
Used for adjustment of the current time.
Push SW to advance the time. Each time the button is
pushed the time advance by 1 minute, pushing continuously
advances by 1 minute at 0. second interval, and when the lower
digit of minute becomes 0 indication advances in 10 minutes
unit.
SW is used for reversing the time. Each time the button is
pushed the time reverses by 1 minute, pushing continuously
reverses the time by 1 minute at 0. second interval, and when
the lower digit of minute becomes 0 indication reverses in 10
minutes unit.
PAC-SA89TA-E
SET BACK DISPLAY
Indicates the setting set
back range.
SET BACK
S M T W T F S
0 3 6 12 15
12 15 18 21 24
WEEKLY DAILY
SETTING SET BACK ON SETTING
ON SET BACK
OFF
CLOCK OFF DAILY TIMER
6
DAILY TIMER SETTING DISPLAY
2 hours is divided into 8 blocks and each
block express 0 minutes.
The block display consists of  pattern.
Set back can be done in the range of 1,2,,6
and 8°C.
SET BACK SETTING SW
Used for set back setting.
ON/SET BACK/OFF SW
Used to specify the time setting pattern.
DAILY TIMER SW
Used for timer setting in 0 minutes unit.
WEEKLY TIMER SW
Used for setting timer in day of week unit.
Pushing SW moves the week day light dis-
play in order of
S → M → T → W ...
enabling to set the week day.