Mitsubishi PKH-1.6GKLH Technical & Service Manual page 32

B
ADDRESS
UNIT No.
FUNCTION No.
A °C
SELECTION No.
AM
PM
FUNCTION
AM
TEST RUN
PM
CHECK
TEMP.
1
ON/OFF
START
MODE FAN
STOP
VANE HR.
MIN.
RESET
82
ADDRESS
UNIT No.
FUNCTION No.
°C
SELECTION No.
BA
AM
PM
FUNCTION
AM
TEST RUN
PM
CHECK
7
TEMP.
ON/OFF
5
START
4 MODE FAN
STOP
VANE
HR.
6
MIN.
RESET
OC229A
<How to operate>
1 Press the ON/OFF button to turn it ON.
2 Press the STOP or START button (TIMER SET).
·
Time can be set while the following symbol is displayed.
OFF timer : A ▼
ON timer : A
3 Use the
HR. and
4 Cancelling the timer.
To cancel the OFF timer, press the STOP button.
To cancel the ON timer, press the START button.
·
24
It is possible to combine both OFF and ON timers.
·
Pressing the ON/OFF button of the remote controller during
3
timer mode to stop the unit will cancel the timers.
<Before test run>
Measure an impedance between the power supply terminal block
on the outdoor unit and the ground with a 500 V Megger and
check that it is equal or greater than 1.0M".
1 Turn on the main power to the unit.
2 Set the Nrm/Set selector switch (on the back of the controller) to <Set>.
AThe FUNCTION , TEST RUN and
3 Press the MIN.
B TEST RUN and current operation mode are displayed.
4 Press the MODE button to activate COOL
whether cool air in blown out from the unit.
5 Press the
FAN
blown out from the unit.
5 Press the
VANE
ates properly.
7 Press the ON/OFF button to stop the test run.
8 After trial run is complete, set the Nrm/Set selector switch to <Nrm.>
3
Note :
·
Point the remote controller toward the inside unit's receiver
while steps 3 though 7 .
·
It is not possible to run the unit in FAN or DRY mode.
2
, B
is displayed.
, B
is displayed.
MIN. buttons to set the desired time.
CHECK
button.
button and check whether strong air is
button and check whether the auto vane oper-
begin to blink.
mode, then check