Mitsubishi PKH-1.6GKLH Technical & Service Manual page 59

OPERATION PROCEDURE
13. REMOVING the SIGNAL RECEIVING P.C. BOARD
(1) Remove the terminal block cover.
(2) Disconnect the connector <yellow> for the wireless remote
controller.
() Remove the front panel. (See Photo 1)
() Remove the 2 screws and signal receiving P.C. board cover.
() Remove the signal receiving P.C. board.
OC229A
PHOTOS & ILLUSTRATION
(Photo 14)
Set screws
Signal receiving P.C. board cover
(Photo 15)
Signal receiving P.C. board
9 9
Front
panel
Front
panel