Turn Off The Sp400X; Remove The Sp400X And Wrist Case - HandHeld SP400X Series System Administrator Manual

Turn off the SP400X

To turn off the SP400X, press and hold the green Power button for three seconds.
IMPORTANT: Turn off the SP400X before disconnecting the battery cable.

Remove the SP400X and wrist case

1. After turning off the SP400X, grasp the battery cable connector and pull straight out.
IMPORTANT:
Do not pull on the battery cable; pull on the battery cable connector that is plugged into the battery.
2. Release the fastener ends of the finger strap.
3. Loosen the finger strap by rotating the front buckle (finger strap buckle) outward about 90 degrees, and then pulling the strap free through
the buckles with your fingers. Repeat on the buckle on the other side until the SP400X is loose enough to easily slide your fingers out.
4. Loosen the wrist strap until the hand can slide out freely.
5. Slide the hand and fingers backwards out of the SP400X.
6. Release and loosen the wrist case straps and slide the wrist case off the arm.
SP400X Series - 5. Operate the SP400X
26