Fit The Hand Mount - HandHeld SP400X Series System Administrator Manual

SP400X Series - 3. Set up the SP400X

Fit the hand mount

IMPORTANT:
Remove all jewelry from your wrist and hand before fitting the SP400X.
1. Loosen the finger strap by detaching the fastener ends and then rotating the buckles outward so that the strap can slip freely through the
buckles.
2. Center the rubberized portion of the finger strap between the buckles.
3. Loosen the wrist strap by releasing the fastener ends and pulling the straps through the buckles.
4. Slide your hand through the wrist strap, palm away from the SP400X.
5. Insert pointer and middle fingers under the finger strap with the rudder positioned between the two fingers.
6. Slide the SP400X onto your hand until the finger strap is at the base of your fingers, and the wrist strap is at the wrist.
16