Print; Print Instructions; Printing Tips - HandHeld SP400X Series System Administrator Manual

SP400X Series - 5. Operate the SP400X

Print

Print instructions

1. Locate a clean, flat surface near the bar code for printing.
2. Place the nose of the SP400X against the surface. The SP400X should rest at an angle of about 7 degrees from vertical.
3. Move the SP400X straight across the surface.
4. When the print is finished, the green light will turn off and the SP400X will emit a Hi tone.
CAUTION:
Maintain a relaxed wrist and hand posture and use low force when printing.

Printing tips

IMPORTANT:
• Keep the printer wheel continuously in contact with the print surface while printing.
1. Print wheel
• Hold the SP400X so that the angle of the device to the surface is approximately 7 degrees.
• Do not push hard on the surface; light pressure will result in better prints, especially with soft packages.
• Do not rotate your wrist. Rotating your wrist while printing can cause skipping or incomplete prints.
24