Table of Contents
Advertisement
GRATE TINE GROOVE
FRONT
Figure 6. Log #3 - Bottom View
Log #3 (SRV2223-702): Position Log #3 as shown in Figure 7. See Figure 2 and Figure 6 for additional references. Mate
the grate tine groove with the base of the left grate tine. Slide the log forward until it stops against the vertical portion of the
left grate tine. Mate the burner top groove with the left edge of the burner top as shown in Figure 7.
LOG PIN SLOT
LEFT
Figure 8. Log #4 - Bottom View
Log #4 (SRV2223-706): Position Log #4 as shown in Figure 9. See Figure 2 and Figure 8 for additional references. Mate
the slot located at the left end of log #4, shown in Figure 8, with the right log pin. Rotate the right end of the log clockwise,
until the log contacts the grate bar.
FLAT SPOT
FOR LOG #7
REST LOG ON
FLAT SPOT
5
3
LINE SHOWS BACK
EDGE OF GRATE BAR
Figure 10. Place Log #5 (Glass Rock not Shown)
Log #5 (SRV2223-704): Position Log #5 as shown in Figure 10. See Figure 2 and Figure 7 for additional references. Rest
the left end of the log on the flat spot of log #3. Locate the groove located on the right end of the log. Mate the groove with
the grate bar. Use the left log pin to positively locate the right end of the log.
Log #6 (SRV2223-705): Position Log #6 as shown in Figure 11. See Figures 2, 5 and 10 for additional reference points.
Place the front and back ends of the log on the flat spots as shown in Figure 11.
BURNER TOP GROOVE
3
4
RIGHT
1
FLAT SPOT
FOR LOG #6
USE LOG PIN TO
LOCATE LOG
Quadra-Fire • QFI30FB-IFT, QFI35FB-IFT Installation Manual • 2555-980 Rev. C • 9/18
LOG #3 TOUCHES
GRATE TINE
BACK
Figure 7. Place Log #3
MATE LOG PIN
WITH LOG SLOT
Figure 9. Place Log #4 (Glass Rock not Shown)
REST ENDS OF LOGS
ON THE FLAT SPOTS
2
Figure 11. Place Log #6 (Glass Rock not Shown)
FLAT SPOT
FOR LOG #5
3
MATE GROOVE WITH
CORNER OF BURNER TOP
4
LOG CONTACTS
GRATE BAR
6
31
Advertisement
Table of Contents
