Table of Contents
Advertisement
UV 72IP
With this feature you are able to control the unit with DMX without the
need of XLR cables. Your DMX controller must be connected to a ADJ
WiFly TransCeiver to use this function. You are able to communicate
up to 2500 feet/760 meters (open line of sight).
1. Turn on the WiFly function using the instructions on page 14.
2. Follow the instructions on page 14 to set the Wireless address.
The address must match the address set on the WiFly Transceiver.
3. After you have set the WiFly address, follow the DMX instructions
on page 12 to select your desired DMX Channel mode and set
your DMX address.
4. Apply power to the ADJ WiFly Transceiver. The fixture must be set
up first before you apply power to WiFly Transceiver.
Note: If the sync does not work, switch the WiFly power off then on
again.
UV 72IP
This feature will let you link units to run in a master-slave mode with-
out the use of XLR cables.
1. Follow the instructions on page 14 to set the Wireless address.
The addresses on each fixture must be the same.
2. After you have set the WiFly address, select your master unit and
set your desired operating mode.
3. Turn on the WiFly function using the instructions on page 14.
4. For the Slave units, put the unit in Slave mode. See page 15
Master-Slave configuration when setting the unit as a Slave. Then
switch ON the WiFly power.
NOTE: If they do not sync up master-slave, switch the Master fix-
tures WiFly off then on again.
ADJ Products, LLC - www.adj.com - UV 72IP User Manual Page 16
WiFly Set Up
WiFly Master-Slave Set Up
UV 72IP
The UC IR infrared remote gives you control of various functions. To
control the fixture you must aim the remote at the front of the fixture
and be no more than 30 feet away. To use the ADJ UC IR you must
first activate the fixtures infrared sensor, to activate the sensor please
see the instructions on page 13.
The Airstream IR remote transmitter plugs into the headphone jack
of your iOS phone or tablet. To control your IR fixture you must raise
the volume to the maximum on your iOS phone or tablet and aim the
transmitter at the fixture sensor and be no more than 15 feet away.
After you have purchased the Airstream IR transmitters, the app is a
free download from the app store for your iOS phone or tablet. The
app comes with 3 pages of control depending on the fixture you are
using. Please see below for IR functions including the corresponding
app page.
Works with App page 1.
STAND BY - Pressing this button will blackout the fixture.
FULL ON - Pressing this button will fully light up the unit.
FADE/GOBO - Press this button to activate fade mode. Use but-
tons 1-4 to select your desired fade speed. 1 being the slowest fade
speed and 4 being the fastest fade speed.
"DIMMER +" and "DIMMER -" - Use these buttons to adjust the out-
put intensity.
STROBE - Press this button to activate strobe mode. Use buttons
1-4 to select your desired strobe speed. 1 being the slowest strobe
speed and 4 being the fastest strobe speed.
COLOR - Press this button to activate UV Dimmer mode. Adjust the
output intensity using the "DIMMER +" and "DIMMER -" buttons.
1-4 - When in either fade mode or strobe mode, these buttons will
allow you to adjust the fade speed and strobe speed.
SHOW 0 - This button is invalid for this fixture.
SOUND ON & OFF - These button's are invalid for this fixture.
ADJ Products, LLC - www.adj.com - UV 72IP User Manual Page 17
UC IR & Airstream App Control
Advertisement
Table of Contents
