Specifications; Before Starting Installation - US Water Systems 169-ISF-1 Owner's Manual

5

Specifications

Carbon Capacity
Tank Size
Service Flow Rates
Normal
Peak
Backwash Flow Rate
Plumbing Connections
Electrical Requirements
Water Temperature
Water Pressure

Continuous operation at flow rates greater than the service flow rate may affect capacity and efficiency performance.

The manufacturer reserves the right to make product improvements which may deviate from the specifications and
descriptions stated herein, without obligation to change previously manufactured products or to note the change.

The above capacity and flow rate specifications have not been validated by WQA.
Tools, Pipe, and Fittings, Other Materials
 Channel Locks
 Screwdriver
 Teflon tape
 Razor knife
 Two adjustable wrenches
 Additional tools may be required if modification to
home plumbing is required.
 The same, or larger, pipe size can be used as the
water supply pipe, but the outlet piping should be
the same as the inlet or smaller.
 Use copper, brass, or PEX pipe and fittings.
 Some codes may also allow PVC plastic pipe.
 ALWAYS install the included bypass valve, or a 3
shut-off valves "H" valve bypass manifold. Bypass
valves allow the water to the conditioner to be by-
passed for repairs if needed, but still have water in
the house pipes.
 5/8" OD drain line (not included) is needed for the
valve drain.
Specifications
US Water inFusion Water Conditioning Systems
169-ISF-1
1.5
10X54
6 GPM
8 GPM
5.0 GPM
Input 120V 50/60Hz - Output 24V

Before Starting Installation

169-ISF-2 169-ISF-3
2.0
12X52 13X54
8 GPM 12 GPM
10 GPM 15 GPM
7.0 GPM 9.0 GPM
1" FPT
Min 39° F - Max. 100 ° F
Min 20 PSI - Max 125 PSI
169-ISF-4
2.5 4.0
16X65
15 GPM
20 GPM
15.0 GPM