The Needle Bar Height - Husqvarna Saphire Series Service Manual

Settings

11.The needle bar height

Check
1. The needle shall be in its centre position, straight stitching.
2. Bring the needle bar to its lower turning position.
3. The gap between the upper end of the needle and the surface (B) of the hook ring should be
28.95 (+ 0.2 mm).
The check is executed with needle bar height gauge which is 28.95 mm long.
Order nr. 412 35 29 - 02
Adjustment
1. Bring the needle to its lower turning position.
2. Loosen screw (A) and move the needle bar until the correct measure is obtained.
3. Tighten the screw.
NOTE! Check by means of a twin needle that the needle bar is not twisted, it may cause jump
stitches when sewing with a twin needle.
A
B
28.95 mm
20 104 72 79-26