Height Of Needle Bar - Husqvarna VIKING E10 Service Manual

Height of needle bar

Check
1. Set pattern selector dial to straight "A".
2. Remove shuttle hook holder.
3. Set needle at its lowest point.
4. Check that the point of the needle and the bottom surface of shuttle hook will align.
Adjustment
1. Remove the face cover
2. Set pattern selector dial to straight "A".
3. Remove the shuttle hook holder.
4. Set needle at its lowest point.
5. Loosen 2mm Allen screw (A) of needle bar bracket.
6. Adjust height of needle by moving the needle bar upward / downward.
7. Stop at the position when the point of the needle and bottom surface of shuttle hook will align.
8. After adjustment, tighten screw (A) of needle bar bracket.
9. Re-assemble the shuttle hook holder accordingly.
10. Attach the face cover.
( A )
12 104 72 72-26