•
Frequency: Set the GWN7600/GWN7600LR's frequency, it can
be either 2.4GHz, 5GHz or Dual-band.
•
Band Steering: When Frequency is set to Dual-Band, users can
check this option to enable Band Steering on the Access Point,
this will help redirecting clients to a radio band accordingly for
efficient use and to benefit from the maximum throughput
supported by the client.
•
Mode: Choose the mode for the frequency band, 802.11n/g/b for
2.4 GHz.
•
Channel Width: Choose the Channel Width, note that wide
channel will give better speed/throughput, and narrow channel
will have less interference. 20Mhz is suggested in very high-
density environment.
•
40MHz Channel Location: Configure the 40MHz channel
location when using 20MHz/40MHz in Channel Width, users can
set it to be Secondary below Primary, Primary below Secondary
or Auto.
•
Channel: Select Auto, or a specified channel, default is Auto. Note
that the proposed channels depend on Country Settings under
System Settings→Maintenance.
•
Enable Short Guard Interval: Check to activate this option to
increase throughput.
•
Active Spatial Streams: Choose active spatial stream if Auto, 1
or 2 streams.
•
Radio Power: Set the Radio Power, it can be Low, Medium or
High.
•
Allow Legacy Devices(802.11b): Check to support 802.11b
devices to connect the AP in 802.11n/g mode.
•
Custom Wireless Power(dBm): allows users to set a custom
wireless power for both 5GHz/2.4GHz band, the value of this field
must be between 1 and 31.
GWN7600/GWN7600LR User Manual
Version 1.0.6.41
P a g e
|
38