Factory reset button. Press for 7 seconds to reset factory default 10-90% RH (non-condensing). settings. ● Do not power cycle your GWN7600LR during system boot up or firmware upgrade. You may corrupt firmware images and cause the unit to malfunction. POWERING AND CONNECTING THE GWN7600LR...
4. Connect the Ethernet cable (RJ45) to the correct ports of your GWN7600LR. 5. Align the GWN7600LR with the Base Bracket and pull it down to the right position. 6. Install the 2x Assembled screws to fix GWN7600LR on the Mounting Bolt.
1. Locate the MAC address on the MAC tag of the unit, which is on the underside of the ● If the GWN7600LR is a slave, make sure to unpair it first, or do a factory reset. device, or on the package.
Page 6
以太网RJ45端口(10/100 /1000Mbps),连接至路由器或另一个 GWN76xx。 恢复出厂设置按钮。按7秒恢复出厂默认设置。 RESET 包装内容 上电和连接 GWN7600LR 通过如下方式可对GWN7600LR 进行PoE供电: Step 1: 将以太网电缆的RJ45端口插入GWN7600LR的网络端口中; 1 x GWN7600LR 无线接入点 1 x 安装支架后盖 1 x 安装支架底座 Step 2: 将电缆的另一端插入交换机的PoE级联端口。 4 x 螺丝 (PM8 x 115) 1 x 六角扳手 4 x 螺丝和螺帽 RJ45电缆连接到以太网供 网络端口...
Page 8
连接到GWN7600LR默认的无线网络 方法2:用GWNDiscoveryTool发现GWN7600LR。 新的GWN7600LR会有默认的WiFi广播。 恢复出厂设置也能使默认WiFi启动。 将GWN7600LR上电起机并连接至网络,GWN7600LR会广播默认的SSID。该SSID是基于 1. 从下面的连接下载GWNDiscoveryTool: http://www.grandstream.com/support/tools 设备的MAC地址后六位: GWN[MAC后六位],并且使用随机的密码。 2. 打开GWNDiscoveryTool,并点击Scan(扫描)。 3. 这个软件将帮助你发现局域网下所有的GWN7600LR并显示他们MAC地址和IP地址。 4. 点击Manage Device(管理设备)后,你将被引导到GWN7600LR的配置界面。或者也可 注意:GWN7600LR的默认SSID和随机密码打印在设备的MAC地址贴纸上。 以通过在浏览器中输入所查找到GWN7600LR的IP地址。 使用上面所述的一种方法,你会看到一个登陆界面。在用户名和密码均输入默认的”admin”, GWN7600LR 点击Sign in (登陆)。 0.5A GigE POE This device has not been authorized as required by the rules of the Federal Communications Commission.