Table of Contents
Advertisement
Chapter 3 Setup
1.
Turning on the Server
Turn on the server by using the following procedure.
1.
Turn on a display, uninterruptible power supply (UPS), and other peripherals.
2.
Connect the power cord to outlet, and wait for at least 40 seconds before pressing POWER Switch. If
STATUS LED is lighting green or amber, wait until it goes off.
3.
Press POWER Switch at the front of the server.
POWER LED is turned on green and after a while, NEC logo appears on the display.
Slot 1
Slot 2
Note
If a power control device such as an uninterruptible power system (UPS) is
connected, check that the power of the power control device is turned ON.
Important
Do not connect or disconnect external USB device while POST is running.
POWER Switch
Express5800/D120h User's Guide
1. Turning on the Server
Slot 3
Slot 4
101
Advertisement
Table of Contents
