NEC EXP710 User Manual page 91

Chapter 2 Preparations
Installing the inner rail
Viewing from the front of this server, install the inner rail with outer rail A on the right side and outer rail B
on the left side.
Installing the outer rail
Mount a rail marked as "A" to the right side of the rack and "B" to the left side when viewed the rack from
front.
Fit the square-shaped protrusions of rail to
the square holes of a 19-inch rack. Push the
locking mechanism and make sure that it
makes a clicking sound indicating that it is
locked.
The image on the right shows the front left
side of the rack. Install to the rear left side
and front and rear right sides following the
same procedure.
Make sure that the rail is installed at the
same height as the other rail already
installed.
(2)
Installing/Removing the Server
Important
Confirm that the rails are securely locked so that they will not fall off.
Tips
Although the rail may be somewhat unsteady, it is not defective.
CAUTION
Be sure to observe the following precautions to use the server safely. Failure to
observe the precautions may cause burns, injury, and property damage. For
details, see Safety Precautions and Regulatory Notices.
• Do not attempt to lift the server with single person.
• Do not drop.
• Do not leave the server being pulled out.
• Do not install with the cover removed.
• Do not get your fingers caught.
Express5800/D120h User's Guide
(1)
2. Installation and Connection
(2)
Push
91