NEC EXP710 User Manual page 61

Chapter 2 Preparations
Raise up the banding band that fixes the
original built-in SAS/SATA cable, and then pull
out the cable. Return the banding band, and fix
it.
Pull out the cable, and remove it while pressing
the lock of the original built-in SAS/SATA
cable. Then, the original built-in SAS/SATA
cable can be removed. Please keep the
removed cable at your hand.
Connect the built-in SAS/SATA cable
(K410-356) to this connector.
Connect the cable also to the SGPIO
connector adjacent to this connector in the
same manner.
SGPIO connector: cable label
[Front] SGPA: SGPA
[Rear] SGPB: SGPB
Pass the built-in SAS/SATA cable (K410-356)
under the banding band, and fix it.
For route of the built-in SAS/SATA cable (K410-356), refer to the following figure.
Although the following figure shows installation of N8103-176/177/178, the cable route when
N8103-188 is installed is the same as this figure.
Express5800/D120h User's Guide
1. Installing Internal Optional Devices
SGPIO connector
[Front] SGPA
[Rear] SGPB
Lock
61