Table of Contents
Advertisement
Chapter 2 Preparations
Connect the internal SAS/SATA cable
(K410-356) to PORT 0-3 connector and
PORT 4-7 connector on RAID controller.
Caution:
Align the label of the cable with the
connector as described below.
PORT 0-3: P1 label
PORT 4-7: P2 label
Fix the bracket with two screws removed in
step 4.
64
Important
Do not touch the terminal part of riser cards or PCI cards and the signal pins of
electric parts installed on the board. Installing boards with dirt or oil can cause
malfunction.
Note
•
Make sure that the head of a PCI card bracket is seated into the fixed slot of PCI riser
card.
•
Depending on type of PCI cards, the terminal part of the PCI card may be too large to
fit in the connector.
•
If you have trouble installing the board, remove the board once and try again. If you
apply excessive pressure on the board, a PCI card or riser card might break.
Express5800/D120h User's Guide
1. Installing Internal Optional Devices
[N8103-176/177/178]
[N8103-188]
PORT 0-3
PORT 4-7
internal SAS/SATA
cable
PORT 0-3
PORT 4-7
Advertisement
Table of Contents
