NEC EXP710 User Manual page 71

Chapter 2 Preparations
Then, remove screws from two locations, and
remove the bracket.
See the table on Chapter2 (1.8.2 Supported cards and available slots) and confirm the slot to install
a card.
Remove one screw from the PCI riser card
and remove the blank cover.
Insert the PCI card to the PCI riser card
while aligning the terminal of the PCI card
with the PCI riser card slot.
To install the PCI board to PCI#2, follow the
same order as steps 8 and 9 in preceding
"(1) RAID controller
(N8103-176/177/178/188), and internal
SAS/SATA cable (K410-356/K410-357)".
Fix the PCI card with the screw removed in step 4.
Note
Keep the removed blank cover for future use.
Important
Do not touch the terminal part of riser cards or PCI cards and the signal pins of
electric parts installed on the board. Installing boards with dirt or oil can cause
malfunction.
Note • Make sure that the head of a PCI card bracket is seated into the fixed slot of PCI riser
card.
• Depending on type of PCI cards, the terminal part of the PCI card may be too large to
fit in the connector.
• If you have trouble installing the board, remove the board once and try again. If you
apply excessive pressure on the card, a PCI card or riser card might break.
Tips
To connect a PCI card to the connector on motherboard with cable, connect a cable to PCI
card before installing PCI riser card.
Express5800/D120h User's Guide
1. Installing Internal Optional Devices
Blank cover
71