Omron V750-BA50C04-US Operation Manual page 72

OT3 Output port #3 function
setting
OT4 Output port #4 function
setting
● If the NML mode is specified in output function setting, you can set conditions by using the following format.
Condition(A)
Condition(B)
Logical operator
* If there is no condition to be set or condition (A) is set, condition (B) shall not be included in the setting.
Ex.) When the characters from 5
"DAT==XXXX0000|TCT>=8"
● In the case that ERR mode is specified for output function setting, you can set conditions with the following format.
Conditions
* If there is no condition to be set, any condition shall not be specified.
Ex.) When communication error or verify error has been occurred,
"dat==7071"
V750 RFID READER/WRITER, ANTENNA
OPERATION MANUAL
Same as OT1
Same as OT1
Dynamic comparison
data
Comparison operators
Static comparison
data
to 8 in read data or when the number of tags is 8 or more,
th th
Error code specifying.
Error code: Specified error has occurred (Max 6 code can be specified.)
ex. "7071"･･･
"DAT": data (リードしたタグデータ)
"TCT": tag count (リードしたタグ枚数)
"==":Data match
"!=":Data unmatch
">=":data value or more
"<=":data or less
When comparison data is "TCT", the code is able to be
specified.
00∼ [Hex]
*mark is a wild card (effective only for Data matched or Data
unmatched )
"&":AND operator
Format: condition A & condition B
"|": OR operator
Format: condition A | condition B
72 of 110
(None)
(None)
2006-06, REV.C
©OMRON CORPORATION 2006