1.3.2 Install the Antennas
The antennas can be mounted directly to a variety of surfaces. Mounting surfaces should be flat to fix the
antenna securely.
To mount the reader on a wall :
1. Hold the antenna in its mounting location and mark the position of the mounting screws with minimum (4)
points. The antenna has several mounting holes for each side. Choose 4 of those with diagonal position
according to the mounting location.
2. Drill holes for the screws and install wall anchors if required.
3. Insert the M4x20 screws with spring washers and flat washers and tighten until almost flush with the wall.
4. Tighten the screws securely.
Note: For best performance, mount the antenna in the horizontal orientation as pictured above.
V750 RFID READER/WRITER, ANTENNA
OPERATION MANUAL
Mounting holes
19 of 110
2006-06, REV.C
©OMRON CORPORATION 2006