Reader Installation; Install The Reader - Omron V750-BA50C04-US Operation Manual

1.3 Reader Installation

The following parts are provided with the reader:
Part
V750-Reader/Writer
Power Supply
I/O Port Connector
IMPORTANT: Be sure the user reads the section on Declarations to maintain compliance with FCC regulations.
The Reader and the antennas are to be installed only by professionals at specific locations For human safety
maintain a 23 cm (9.1 in) distance from the antennas.
IMPORTANT: This product is intended to be supplied by a Listed AC Adapter (Switching Power Adapter)
marked LPS and rated 12 Vdc, 4 A

1.3.1 Install the Reader

You can place the reader on a shelf or mount it to a wall. Mounting shelf and wall should be flat to fix the
reader securely.
To mount the reader on a wall:
1. Hold the reader in its four mounting location and mark the position of the mounting screws
Mounting holes
2. Drill holes for the screws and install wall anchors if required. Be sure anchors must have enough strength
to fixed the reader against vibration.
3. Hold the reader at the position on the mark and insert the M4x16 screws with spring washers and flat
washers, and tighten until almost flush with the wall. Two persons (one for hold the reader and the other for
tighten the screws) are required for this installation for the safety.
4. Tighten the screws securely.
5. Place the AC adaptor where it is not obstructed and Fix it so that not to move by vibration and tense DC
plug cables. Do not bundle the adaptor cable with other signal or power lines.
IMPORTANT: Be sure to remain within the rated voltage and current of the power cord and outlet.
Mechanical Loading - Mounting of the equipment in the rack should be such that a hazardous condition is not
achieved due to uneven mechanical loading.
V750 RFID READER/WRITER, ANTENNA
OPERATION MANUAL
Quantity Part Number
1 V750-BA50C04-US
1 -
1 -
V750
画像
18 of 110
2006-06, REV.C
©OMRON CORPORATION 2006