Antenna Port - Omron V750-BA50C04-US Operation Manual

1.3.4 Antenna Port

One to four OMRON Mono-static antennas (V740-HS01CA, V740-HS01LA) can be connected to the reader,
depending on the application requirements.
1. Connect required UHF antennas to the antenna ports on the reader .
IMPORTANT: Connect antennas to the antenna ports before applying power to the reader. Any antenna
port not having an antenna connected to it will be disabled when the reader is powered on.
Antenna Connection: V750-BA50C04-US
Note: With the two antenna configuration, there is a possibility that a tag may be read by an inactive
antenna if the tag is located with in approximately 20 cm of the inactive antenna.
2. Verify that all antennas are securely connected.
3. Connect the reader to the network by plugging a Shielded Ethernet cable into the Ethernet port.
or
Connect the reader to a PC (personal computer) by plugging a crossover Shielded Ethernet cable into the
Ethernet port.
Note: If DHCP is to be used, then the network and server must be connected before powering up the
reader. If a DHCP server is not found, the reader will fall back to the IP address:
V750 RFID READER/WRITER, ANTENNA
OPERATION MANUAL
V750
画像
21 of 110
Antenna x 4
(V740-HS01CA or V740-HS01LA)
Antenna Cable x 4
(V740-A01-3.0M or V740-A01-10M)
©OMRON CORPORATION 2006
2006-06, REV.C