Overview Of Log Entries - HEIDENHAIN iTNC 530 HSCI Service Manual

8.4 Overview of log entries

Entry
RESET
ERR
INFO "xxx"
INFO CTRL KINEMATIC
INFO CTRL collision
INFO CTRL REG
AXIS xx START REF=yy
INFO CTRL REG
AXIS xx STOP REF=yy
INFO MAIN ERRCLEARED
INFO MAIN ERR_RECURED
INFO MAIN ENDAT
INFO MAIN RUNPROC
KEY
INFO MAIN SOFTKEY
Control-in- ON
a
operation
OFF
BLINK
a. Control-in-operation symbol = " * " in the screen display
February 2012
Description
Restart the control
Error messages
P
--> PLC error message with the line number in the PLC error text file
N
--> NC error message with number
Power fail interrupt!
--> The control was switched off by a POWERFAIL.
Result of the file system test:
If the control is not properly shut down, the file system is checked during
the next startup and the result is entered in the log.
--> Search for "dosfsck" in the log.
"xxx": Name of the control process that enters the information in the log
PLC
SYS
MAIN
REMO
CTRL
SMARTNC
SMARTNC_LDF
BDEHAN
SOKY
GEO
PYTHON
FIXTURE
FILEMAN
Active tool with tool number, radius (R=) and length (L=)
Status of collision monitoring in the Manual and Automatic operating modes
Position yyyy of axis xx at start of movement
Position yyyy of axis xx at stop of movement
Acknowledgment of an error message
Error message entered several times
Entry for the position upon switch-on, if the switch-off and switch-on positions
of an EnDat encoder do not match
Status information about the current process
Keystrokes
Path with associated image file of a pressed soft key
Control-in-operation on
Control-in-operation off
Control-in-operation symbol blinking
8 – 83