HEIDENHAIN iTNC 530 HSCI Service Manual page 603

MP Function and input
MP3420 Spindle positioning window
MP3430 Deviation of the reference mark from the desired position (spindle preset)
MP3440.0-7 k factor for spindle orientation for gear ranges 1 to 8
V
MP3450.0-7 Number of spindle position-encoder revolutions for gear ranges 1 to 8
MP3451.0-7 Number of spindle revolutions for gear ranges 1 to 8
MP3510.0-7 Rated speed for the gear ranges 1 to 8
MP3515.0-7 Maximum spindle speed for gear ranges 1 to 8
MP3520.0 Speed activation through marker M4011
MP3520.1 Spindle speed for oriented stop
MP3530 Increased spindle power for roughing
MP3540 Permissible spindle speed shortfall
MP3542 Minimum spindle speed as of which the monitoring in MP3540 becomes active
MP3550 Delay of emergency-stop reaction of spindles
31 – 604
Input: 0 to 360.0000 [°]
Input: 0 to 360 [°]
Input: 0.1 to 10 [(1000°/ min) /°]
Input: 0 to 65 535
0: No transmission
Input: 0 to 65 535
0: No transmission
Input: 0 to 99 999.999 [min
Input: 0 to 99 999.999 [min
Input: 0 to 99 999.999 [min
Input: 0 to 99 999.999 [min
Input: 0 = Not active
1 = Increased spindle power for roughing
Input: 0.001 to 0.999
0: Monitoring not active
Input: 0.001 to 0.999
0: Monitoring not active
Input: 0.001 to 0.100 [s]
0: Delay not active
–1
]
–1
]
–1
]
–1
]
HEIDENHAIN Service Manual iTNC 530 HSCI
Software
version and
behavior
PLC
RUN
PLC
RUN
PLC
RUN
PLC
RUN
PLC
RUN
PLC
RUN
PLC
RUN
PLC
RUN