Restoring Data - HEIDENHAIN iTNC 530 HSCI Service Manual

14.6 Restoring data

When restoring the backup of a machine, the data (e.g., PLC data, TNC data, "full backup") is restored
from an external data medium (e.g. laptop) to the control.
Connection setup
Selecting the In the upper screen half (laptop/PC contents), select the drive and the directory where you have
backup file stored the backup file.
February 2012
Attention
The machine must not operate while the data is being restored!
The control should be in Power interrupted condition.
Never press any key on your control while data transfer is running!
Note
If you work with Ethernet connection, check or make the necessary settings. --> See "Connection
setup" on page 14 – 183.
Tip: For the original settings for the Ethernet interface, refer to the file if0.cfg which you have
extracted, e.g., from the full backup of the corresponding machine. --> See "Extracting files from
the backup file" on page 14 – 206.
Set up a connection to the iTNC 530 HSCI via TNCremoNT.
--> See "Connection setup" on page 14 – 183.
Click the bar with the drive information. --> Its color changes, and two buttons appear at the right
side in the bar.
Click the Change folder/drive... button. --> A new window opens.
Now, select the drive and the folder (in the example: C:\Backup Machine Hugo). --> The path is
displayed in the bar.
14 – 207