Recording And Adjusting The Signals - HEIDENHAIN iTNC 530 HSCI Service Manual

10.3 Recording and adjusting the signals

The selected signals are recorded continuously.
After recording ends, the memory contents are displayed.
You can stop the recording anytime by hand with the STOP soft key.
Vertical resolution Now, adjust the amplitude of the signals:
February 2012
Press the OSCI soft key.
Press the START soft key.
Note
The oscillogram remains stored until you start a new recording.
Switch to the next soft-key row and use the following soft keys:
Shift the signal downward.
Shift the signal upward.
Decrease the vertical resolution.
Increase the vertical resolution.
Optimum vertical resolution; the signal is centered on the vertical center and always
remains in the display area.
Optimum vertical resolution under consideration of offsets to the zero line.
Select the next channel with the arrow keys on your keyboard and adjust the signal amplitude there.
Proceed accordingly with the other channels.
Note
The selected channel is distinguished by a frame.
At the same time, the cursor is placed on the selected channel.
The active channel and the corresponding signal are mostly displayed in red color.
10 – 101