Table of Contents
Advertisement
IV.
High speed mode.
A. Pm 14 on electronics module should have 12 volts.
B'
5h&C13for 12 V°ltS 3t Wgh Spe6d terminals to motor(s), Pins
1-
If not present replace electronics module.
2.
If present, check motor windings and grounds.
PROBLEM:
Mist mode fails to operate.
CHECK/SOLUTION:
I*
Pm 15 on electronics module should have 12 volts.
A.
If present, replace electronics module.
B.
If not present, replace "smart stick" switch.
PROBLEM:
—cycle—fails—to^ operate or operates imnrnp.rh,
CHECK/SOLUTION:
I.
Windshield washer does not pump and wipers do not work.
A.
Pin 17 on electronics module should have 12 volts.
1"
^ present, replace electronics module.
2.
If not present, replace "smart stick" switch.
II.
Windshield washer pumps water, but wipers do not work.
A.
Verify Pin 17 has 12 volts.
I-
If present, replace electronics module.
III.
Windshield washer does not pump but wipers work.
A.
Inspect for proper fluid level in washer bottle reservoir.
B.
Check for proper ground connection at washer pump.
C.
Check Pin 16 for 12 volts and good connections.
1.
If present, check for 12 volts at pump motor.
2.
If present, replace motor
3.
If not present, replace electronics module.
C-38
Advertisement
Table of Contents
