Table of Contents
Advertisement
C.
Mop out any remaining water in the Ice Maker mold.
D.
Leave door propped open two inches so that humidity will not
build up inside the cabinet and corrode the microswitches.
12.
Remove any items (food, cosmetics, etc.) from the interior that might
be damaged by freezing, or might damage the motorhome if containers
break.
For additional winterizing protection add non-toxic antifreeze (approved for
drinking water systems) to your water lines using the following procedure:
1.
Reconnect all lines except the hose to the pump inlet port.
Close all
drain valves (See Step 3).
3.
Turn bypass valve to bypass position.
Access to the bypass valve in
the 36 foot model is in the bottom of the wardrobe just forward of
the bathroom.
The 32 foot basement model access is through the
bottom access panel below the wardrobe sliding doors.
3.
Attach a length of hose to the pump inlet port.
This piece of hose
should be long enough for the free end to be inserted into and reach
the bottom of the antifreeze container.
4.
Dilute the antifreeze solution in accordance with the manufacturer s
instructions.
5.
Open all water faucets.
6.
Insert hose length into the antifreeze container, turn the pump switch
on, and run the water pump until the antifreeze solution fills all water
lines and the water heater.
Flush toilet.
Work shower hand spray
while holding down in tub.
7.
Shut off the pump and close all faucets.
8.
Disconnect
the
hose
length from pump
inlet fitting and
reconnect
water system inlet line.
G-41
Advertisement
Table of Contents
