Table of Contents
Advertisement
SERVO TEST (ENGINE MUST NOT BE RUNNING)
1.
Disconnect the servo harness in the engine compartment.
Supply a ground to the orange and green wires.
Apply 12 volt to the blue and yellow wires.
LVOlt applied t0 the blue and yellow wires, and ground supplied
o the orange and green wires, the servo should pull thecabie in.
ST5irK-eh toiSanntacheCrn7 tD pul1 'he
throttle when testing;
lockS and will
t h
adequate.
During this test the servo clutch
the servo or the throttlTltakage will "Sir""8 *° aPP'y V°ltage' damage to
PLEASE USE EXTREME CAUTION WHEN PERFORMING THIS TEST!!
2
.
3.
4.
CONTROL SWITCH TEST
1.
Remove electronics package.
2.
Connect one lead of ohmmeter to Pin 6 of the connector.
3.
Set the ohmmeter range to RX100.
4.
Sallow,,°ther 0hmmeter lead t0 plns 1 through 5 in tur" 'refer to
5.
activated'the meter
should read
6.
ta
switch activated'the
read 0 ohms
PIN
NUMBER
SWITCH
FUNCTION
SWITCH
OPEN fWOT IFTU/ATcm
POSITION
1
RESUME/ACCEL
INF
CLOSED (ACTIVATED)
0
2
RESUME/ACCEL
INF
0
NONE
INF
0
4
SET/COAST
INF
0
5
ON/OFF
INF
0
6
GND
—
-
C-34
Advertisement
Table of Contents
