Table of Contents
Advertisement
REMEDY:
PROBLEM:
CAUSES:
REMEDY:
D. Power wire connected to converter.
E. Defective panel.
1. Test panel with module tester or replace panel to see if the
same problem occurs.
2. Check all connections for looseness, etc.
3. Pads should be only on vertical faces and both pads should
run from near the top edge of the tank to near the bottom
edge of the tank.
If the tank is stepped, put the pads only
on the vertical faces of the tank.
Connect the vertica
pads across step with a thin (1/4") strip of foil.
4
If the pads are made of vertically run strips of aluminum
foil tape, run a few strips of foil tape horizontally across
the vertical strips (cross-hatching).
If the strips making up
the pads are horizontally run, cross-hatch vertically.
5. Make sure the pads are stuck firmly to the tanks.
6. Connect
the
power
wires
as
close
to
the
battery
as
possible.
LPG not working (if panel is equipped with one).
A. LPG not connected properly.
B. Sending unit bad.
C. LPG float bad.
D. Defective panel.
1. Test panel on module tester or replace panel to see if
problem still occurs.
2. Ground red wire from connector.
LPG should read empty.
Disconnect red wire.
LPG should read full.
3. Check to see that the red LPG wire in the connector to the
panel is in the proper slot m the connector.
On the
horizontal models, the proper slot is in the 7th from the
too.
On the 106 vertical models, the proper slot is in the
7th from the left.
On the 105 models, the proper slot is in
the 11th from the left.
On the HRC models the proper
hole is the middle vertical row, second horizontal row from
the top.
(The top of the connector has 2 notches mi.)
H-21
Advertisement
Table of Contents
