Table of Contents
Advertisement
PROBLEM:
CAUSE/
REMEDY:
PROBLEM:
CAUSE/
REMEDY:
PROBLEM:
CAUSE/
REMEDY:
PROBLEM:
Cause/
REMEDY:
PROBLEM:
CAUSE/
REMEDY:
Unit spits after drawing four or five cups of water.
Aspirator orifice not round.
Replace complete assembly.
Aspirator ball not round, flat spots.
Replace aspirator ball.
asTimbl0/.
baH
tUbe
n0t
att3Ched
pr°perly-
Replace
tank
water. ^
"Spitting"
is normaI when drawing quantities of
Unit drips every 20 minutes when thermostat comes on
Thermostat set too high.
Adjust thermostat.
Expansion chamber full.
Check for low water pressure
Spout not fully
until it bottoms.
seated.
Loosen set screw, push spout down
Tighten set screw.
S;r°SaL- u,°Unti?g, StUd bent'
Not Perpendicular to tank
.
Straighten stud.
Should be 90 degrees to tank face.
Water continuously drips from spout.
Valve
not
seated
due
to
foreign
object,
remove foreign object.
Tee nut not adjusted properly.
Adjust tee nut.
Valve disc missing.
Install valve disc.
Metal valve seat defective.
Replace unit.
Disassemble
and
Water leaks around spout.
Valve stem bushing not tight.
Tighten bushing.
Large and/or small "O" ring damaged, cut, missing, etc.
or replace both large and small "O" ring.
Install
biased""11"1165 t0
fl°W
f°r °ne {° tw° seconcls
after
a
Normal
G-24
Advertisement
Table of Contents
