Table of Contents
Advertisement
Trouble Shooting Guide
PROBLEM:
CAUSE/
REMEDY:
PROBLEM:
CAUSE/
REMEDY:
PROBLEM:
CAUSE/
REMEDY:
Water will not stay in bowl.
(See Fig. 6)
Loose clamp ring.
Tighten clamp ring adjusting nut.
Improper
seal
around
flush
ball
due
to
dirt
or
debris
on
oTSr
«rct ,lush
baU
""
Worn or damaged flush ball.
Replace flush ball.
Cracked half clamps.
Replace half clamps.
Plastic flush ball will not close completely.
(See Fig. 6)
STbS® LoSefcTamp rtag""® *°°
weak or defective spring.
Check spring tension bv letting
ud
on flash lever suddenly
if lever does not "snap back' replace
pring, cam and plate with new spring cartridge.
Worn or damaged flush ball or shaft.
If
shaft
C'°eS n0t c^ose completely,
lever "snaps back" but
replace flush ball and
Water doesn't shut off in toilet (toilet overflows).
(See Fig.
vaWe!°dSed in W3ter V3lVe SeaL
Disassemble and clean water
Cam strap bent down holding water valve
cam strap up about 1/16".
open.
Bend front of
Worn or defective water valve.
Replace valve assembly.
Worn or defective spring,
new spring cartridge.
Replace spring, cam and plate with
G-34
Advertisement
Table of Contents
