Table of Contents
Advertisement
Start the engine and drive to a level roadway where the legal speed limit is
t-r mnh
Slide the "On/Off" switch on the control arm to the on position.
Now accelerate to about 35 MPH and momentarily push in and release the
"Set/Coast" button.
The cruise control is now m operation and the engage
liaht
Should be brightly lit.
Depress the brake pedal (press the brake just
hard
enough to activate the brake light switch).
The cruise control should
disengage and the engage light should go out.
Accelerate to 55 mph.
Hold that speed and momentarily push in and release
thP "^et/Coast" button.
The cruise control should hold the vehicle at tne
set speed
If not
adjust the centering screw either up or down until the
vehicle speedometer reads 55 mph.
-Power
Eleclronjc-
Modu!®
•Engage
Light
Increase
-1
\
— Centering —
Adjustment
Tap the brake pedal to disengage the cruise control.
Allow the vehixde^J:o
slow down to about 45 mph and then turn the controlarm
f s U
position.
The cruise control should engage and accelerate the vehicle bac
to 55 mph.
Sensitivity Adjustment
Note-
Normally no adjustment of the electronic sensitivity is required as it
rnr'eset at the factory.
Sensitivity affects the cruise control accuracy
and" not the acceleration rate.
If the vehicle has poor response, see the
trouble shooting guide.
Sensitivity adjustment can be made if one of the following conditions exist.
Condition
Solution
Vehicle is not holding speed on
Sensitivity should be increased,
mild hills.
.
.
Sensitivity should be decreased.
Vehicle is surging.
y
Sensitivity should be increased.
Sensitivity should be decreased.
Electronic
Module
-Power
tight
-Engage
Liont
Increase'!
- System —'
Sensitivity
Adjustment
C-29
Advertisement
Table of Contents
