Isolating Cables - Pro'sKit MT-7071 User Manual

Isolating Cables

To isolate the tone source in the cable bundle or at the patch panel, do the steps
as described in the previous section of "Locating Cables".
7. Divide the wires into two parts, and separate the two bundle wire in
30~45 centimeter, use MT-7071 receiver to scan each part, which
part get the louder buzzer sound and the LED light is more bright
(Stronger signal), that part should include the target wire, do the same
way to check until find out the target wire.
8. Adjust the volume control from high to low to enable looking for a
more difficult to identify wire. Narrowing the length from 30 to 10
centimeters will help to more accurately identify the wire pairs.
9. Repeat the steps of 6 and 7 to isolate the bundled cables.
Caution
•
If user could not distinguish the signal strength at each part, perhaps the
cable status is short or open, perform Continuity Test (refer to figure 11)
to check the cable status.
Figure 9 Isolating Cable
22